The front panel was designed to match the grille of the higher-tier trim levels, although it looks excellent with the lower-tier trim levels as well. Behind this cutaway pattern, a Dual Row 20-inch LED light bar can mounted. It features pod light mounts on each side of the bumper, that fit 2 pods each.
The Adaptive Cruise Control sensor module must be relocated if the vehicle is equipped with ACC. Our ACC Relocation Bracket is sold separately, available in the drop-down options to the right.
OE Plus Series Front Bumper Features:
- 20” Dual Row Light Bar Mount
- (4) 3” Pod Light Mounts
- 3-Piece Design
- 2-Stage Micro-Texture Black Powder Coating
- 4mm body and 5mm mounts/supports
- Reinforced D-Ring Mounts
- Compatible with Factory Plastic and Metal Skid Plates
- Does not Interfere with 360° Camera
- Works with Factory Parking Sensors
- 3-Piece Construction
- Ford Bronco - Base , Big Bend, Black Diamond, Outer Banks, Badlands, Wildtrak, First Edition
Carries OEM Styling
The OE Plus Series was designed to closely follow factory styling, while providing enhanced features. The cutaway pattern at the center of the bumper matches the grille pattern of the Badlands, Wildtrak, and First Edition Broncos.
Low Profile Fitment
This bumper fits tight to the lines of the Bronco, and maintains high clearance and approach angles. Without the need to fit a winch, we've kept this bumper slim.
Protected Light Bar Mount
Behind the grille matching cutaways at the center of the OE Plus Series Front Bumper are mounts for a dual row 20-inch light bar. The cutaways allow light through, but also protects the light bar from damage if you ram anything on the trail.
Two Side Pod Light Mounts
If you're looking to supplement your trail lighting for dark conditions, there are two additional pod light mounts towards either side of the bumper.
Retains OEM Parking Sensors
The OE Plus Series Front Bumper retains the OEM parking sensors. If your Bronco did not come with parking sensors, we've included sensor hole plugs.
Two D-ring Mounts
There are two mounts that take 3/4-inch D-rings in order to provide recovery options when driving off-road.
Front Camera Visibility
View of the front camera with the OE Plus installed.
Additional Information:
- D-Ring Mount Included: Yes
- Winch Compatible: No
- Width: Full
- Weight: ≈ 59 lb.
- Light Mounts Included: Yes
- Fitment: Direct Fit
- Finish: Micro Texture Black Powder Coat
- Material:Steel & Aluminum
- Parking Sensor Compatible: Yes
- Adaptive Cruise Control: Must be relocated for bumper to fit.
- Front Camera: Bumper is partially visible, but does not impede lane detection.
- Factory Skid Plate: Both plastic and metal skid plates fit with this bumper.
- Factory Fog Lights: Do not fit in bumper.
Installation:
- This bumper takes approximately 1.5 hours to install.
- 2 people are needed to safely lift the bumper into place.
